废水中甲基橙的电化学降解

以FTO导电玻璃作为阳极、石墨电极作为阴极电解模拟甲基橙废水,优化了工艺条件,并对甲基橙的降解机理进行了初步探究。实验结果表明,在NaCl投加量5 g/L、电压8 V、废水pH 6、初始甲基橙质量浓度6.0 mg/L的优化条件下电解30 min,废水的脱色率达91.3%,COD降低了62%。机理研究结果表明,电解产生的羟基自由基与甲基橙发生氧化还原反应,破坏了甲基橙的显色基团,使其内部某些化学键发生断裂,从而达到脱色的目的。     

含氮生物降解促进剂对土壤吸附正十六烷的影响

选用正十六烷模拟润滑油,通过振荡平衡实验,考察了两种含氮脂肪酸型生物降解促进剂（甲基二乙醇胺油酸酯（MDEAO）和油酸二乙醇酰胺（ODEA））对水土体系中正十六烷吸附行为的影响。实验结果表明：正十六烷在水土体系中的有机质标化分配系数与土壤种类无关,与生物降解促进剂种类有关;土壤对正十六烷的吸附过程更符合Freundlich等温吸附模型;MDEAO的临界胶束浓度为2.0 mg/L,对土壤吸附正十六烷有一定的促进作用,ODEA的临界胶束浓度为0.7 mg/L,形成的胶束对正十六烷的增溶效果明显,促进了正十六烷在土壤中的解吸。     

聚苯乙烯/CdS/TiO_2双壳层核壳纳米颗粒可见光催化降解甲基橙

采用溶胶-凝胶法,在聚苯乙烯(PS)/CdS核壳纳米颗粒表面包覆致密TiO_2层,制备出具有双壳层结构的PS/CdS/TiO_2纳米复合颗粒,考察了制备条件对材料结构的影响,并利用甲基橙溶液对其光催化性能进行了评价。SEM、TEM、XRD和FTIR分析结果表明,制得的微球单分散性良好,壳层包覆完整,厚度均匀。PS/CdS/TiO_2制备的适宜反应时间为12~18 h,适宜反应pH为7~9。PS/CdS/TiO_2较PS/CdS具有更为优异的可见光催化性能。     

PW_(12)/g-C_3N_4光催化降解甲基橙

采用浸渍法制备了磷钨酸(PW12)/g-C3N4复合光催化剂,并将其用于溶液中甲基橙的光催化降解,运用IR技术对使用前后的光催化剂进行了表征。表征结果显示,PW12和g-C3N4的结构未在浸渍负载中发生改变,且PW12和g-C3N4结合牢固。实验结果表明:最佳的PW12负载量(光催化剂中PW12的质量分数)为50%;光催化降解甲基橙的优化反应条件为初始甲基橙质量浓度5 mg/L、光催化剂加入量0.6 g/L、初始溶液p H=7;在优化条件下,分别采用紫外光、模拟太阳光、可见光照射120 min后,甲基橙的降解率分别为96.59%,82.23%,42.78%;该光催化剂固载良好,使用中不易发生溶脱,稳定性好,可重复使用。     

MCM-41分子筛负载铁铈催化降解甲基橙

采用等体积浸渍法制备了负载型有序介孔Fe-Ce/MCM-41催化剂。研究了该催化剂降解甲基橙的适宜工艺条件,并采用XPS,XRD,TEM技术对该催化剂进行了表征。实验结果表明,该催化剂Fenton氧化降解甲基橙的较适宜工艺条件为:溶液pH 5.0、甲基橙溶液初始质量浓度100 mg/L、催化剂加入量2.0 g/L、H_2O_2浓度20 mmol/L,在此适宜条件下反应120 min时,甲基橙去除率接近100%。表征结果显示:Fe-Ce/MCM-41催化剂主要由铁、铈、氧、碳4种元素组成;铁与铈的摩尔比接近3∶1;铁和铈主要以Fe_3O_4和CeO_2的形态存在于催化剂表面。     

Effects of EGR on performance and emissions of a diesel engine fuelled with balanites aegyptiaca/diesel blends

In this study, balanites Aegyptiaca (L.) Del biodiesel was blended in proportions of 10% and 20% on the volume basis with diesel fuel and tested in a single cylinder, VCR diesel engine under measured load conditions with varied EGR rates (0, 10 and 20%). The results showed that B10 and B20 blends shown a significant reduction rate in terms of NO_x emissions that were familiar with biodiesel blends. At peak load conditions, BTE increased slightly for test fuel blends compared with pure diesel fuel while the BSFC rate and EGT suffered from increasing and decreasing nature with respect to blending percentage. From the emissions point of view, with the increase in blends percentage, a significant reduction rate is observed in terms of CO and HC concentrations (up to 12.34 and 17.5%, respectively) while NOx emissions decreased at peak load conditions (up to 24.34%). HC and CO emissions decreased with increase in blends percentage. However, lower levels of NO_x and EGT (up to 21.37 and 8.47%, respectively) and the average increase in terms of BTE and BSFC (up to 2.83 and 2.9%, respectively) can be realised with B20 test fuel blend under 20% EGR rate.     

交联壳聚糖-CdS颗粒可见光催化脱色甲基橙研究

利用壳聚糖对金属离子的配位络合作用和吸附性能,模拟生物矿化仿生制备交联壳聚糖/CdS复合粒子。以甲基橙为处理对象,氙灯模拟可见光,研究了该复合材料对甲基橙的降解脱色性能。用Langmuir-Hinshelwood方程从动力学的角度,考察了不同催化剂浓度、甲基橙的初始浓度、反应体系的pH值、外加无机阴离子等对甲基橙降解脱色的影响。结果表明,该复合材料的吸附性能和光催化活性产生的协同作用能较有效促进甲基橙染料的脱色,在低质量浓度条件下可见光催化过程为假一级反应。光催化剂的最佳用量为1.5g/L,甲基橙降解的最佳pH为4.0。Cl-和Br-均对MO的光催化脱色起抑制作用,而NO3-的添加明显促进MO的光催化速率。     

Fenton法氧化甲基橙溶液的脱色动力学实验研究

实验对甲基橙的Fenton氧化脱色降解反应过程进行了研究,结果表明在pH值为3、反应温度为30℃的反应条件下,Fenton试剂氧化甲基橙溶液脱色反应可以用一级动力学过程来描述,而且其反应速率常数受到亚铁离子初始浓度和过氧化氢初始浓度的影响很大,经过数据拟合分别得到了反应速率常数与亚铁离子初始浓度和过氧化氢初始浓度之间的数学关系。实验还对30℃～60℃不同温度下的Fenton反应过程进行了考察,结果表明不同温度下Fenton氧化甲基橙的脱色反应仍可以用一级动力学过程来描述,而且其反应速率常数受温度变化的影响不大,基本保持恒定。     

高度有序的TiO2纳米管阵列光催化性能研究

采用恒压阳极氧化法在纯钛箔表面制备TiO2纳米管阵列,利用SEM和XRD对其进行了形貌和晶型的分析和表征,并通过TiO2纳米管阵列膜对甲基橙光催化降解,探讨光照时间、甲基橙溶液的初始浓度、溶液的初始pH值和H2O2加入浓度等因素对甲基橙的脱色率影响.结果表明,H2O2加入浓度为50mg·L-1,紫外光照射2h,溶液为中性时,在30 mg·L-1的甲基橙溶液(50mL)中,甲基橙溶液的脱色率达到100%.当H2O2加入浓度进一步增大到100 mg·L-1时,光催化的效率进一步提高,紫外光照射1h,甲基橙溶液的脱色率就已经达到了100%,并未出现抑制光催化的现象.同时还研究了TiO2纳米管阵列电极的稳定性.实验结果表明,随着TiO2纳米管阵列使用次数的增加,其光催化效果略有所下降.     

Sensitivity of green and blue-green algae to methyl tert-butyl ether (MTBE) during a fifteen-day test

The test was designed to assess the toxicity of methyl tert-butyl ether (MTBE) to Chlorella ellipsoidea and Aphanizomenon flos-aquae during 15 d with concentrations of MTBE from high (2.00×104 mg/L) to low (2 mg/L). The results showed that the toxicity was low when the concentration of MTBE was 1.00×104-2.00×104 mg/L (the greatest inhibition of growth-rate was 70%-71%, occurring on day 1-5). Low concentrations (2-500 mg/L) stimulated algal growth up to the greatest effect of 85%-200% when the concentration of MTBE was 50-100 mg/L on day 3-5. The low concentrations may lead to an algal bloom owing to overabundance, which represents an aquatic ecological risk. However, the stimulatory effect occurred only during the day 1-5 and disappeared gradually during the day 13-15. The toxicity of MTBE (72-120 h EC50) is 6.65×103-9.58×103 mg/L for C. ellipsoidea and that is 1.14×104-2.00×104 mg/L for A. spiroides. We found that the toxicity and ecological risk of MTBE for the algal community structure were low. The toxicity was influenced by the duration of the test. We suggest that the duration of the test should not be shorter than half a life-cycle.